Management                                                                          

The Management screen allows you to change the Router's security settings. It is strongly recommended that you change the factory default password of the Router, which is admin. All users who try to access the Router's web-based utility or Setup Wizard will be prompted for the Router's password.

 

Router Password

 

The new Password must not exceed 32 characters in length and must not include any spaces. Enter the new Password a second time to confirm it.

HTTPS Web Access

Allows you to configure https access to the router\'s web utility.

Remote Management

 

This feature allows you to manage your Router from a remote location, via the Internet.  To disable this feature, keep the default setting, Disable. To enable this feature, select Enable, and use the specified port (default is 8080) on your PC to remotely manage the Router. You must also change the Router's default password to one of your own, if you haven't already. A unique password will increase security.

 

To remotely manage the Router, enter http://xxx.xxx.xxx.xxx:8080 (the x's represent the Router's Internet IP address, and 8080 represents the specified port) in your web browser's Address field. You will be asked for the Router's password. After successfully entering the password, you will be able to access the Router's web-based utility.

 

Note: If the Remote Management feature is enabled, anyone who knows the Router's Internet IP address and password will be able to alter the Router's settings.

SNMP

 This feature allows you to manage your router from a MIB browser. To disable the feature, keep the default setting Disable, select Enable to enable it.

Contact: The textual identification of the contact person for this managed node, together with information on how to contact this persion.
Device Name: An administratively-assigned name for this managed node. By convention, this is the node's fully-qualified domain name.
Location: The physical location of this node (e.g. 'telephone closet, 3rd floor').
Get Community: the community used to getting variable(s) from device.
Set Community: the community used to set variable(s) to device.
SNMP Trap-Community: the community used by event of traps.
SNMP Trap-Destination: The IP Address of destination traps send to.

UPnP

Used by certain programs to automatically open ports for communication.

Multicast

Used to establish host memberships in particular multicast groups on a single network.

 

Check all the values and click Save Settings to save your settings. Click Cancel Changes to cancel your unsaved changes.