Management
Local Router Access
|
Router Password |
Enter the password you choose for this Router. This is needed to gain access to the Web-based Utility. |
|
Re-enter to confirm |
Enter the password chosen above to confirm that you properly entered the password. |
Remote Router Access
|
Remote Upgrade |
This option allows for upgrading the Router's firmware from a remote location. |
| Remote Administration | This option allows you to access the Web-based Utility from a remote location. |
|
Administrator Port |
Enter the port number you want to use to access to the Router from a remote location. |
To access the router from the remote location
Enter the following in the URL of your web browswer:
http:// <internet IP address of the Router>:<Administrator Port>. For example, if your IP address is 1.2.3.4 and you set the administrator port number to be 5204, you would enter the following:
SNMP
The router supports Simple Network Management Protocol (SNMP), which is a widely used network monitoring and control protocol. This allows network supervisor to monitor the Router using network management systems such as Openview.
| Enabled/Disabled | To turn off SNMP, select Disable. |
| Identification | Shows The current device name of the router. |
| Get Community | Enter a name for any SNMP community with "Read-Only" accessibility. The default community is public. |
| Set Community | Enter a name for any SNMP community with "Read-Write" accessibility. The default community is private. |
|
UPnP |
Select Enabled to allow UPnP communication between the Router and the computer that is UPnP compliant. By default, UPnP is Disabled. |
| Allow users to make Configuration Changes | This options allows users to make changes using windows XP utilities. For example, you can make changes that are configurable through Windows XP utility. |
|
Allow users to Disable Internet Access |
This option allows users to disable Internet access by disabling network connections in Windows XP. |
Click Save Settings to save any changes.