|
Setup |
Server Name
The Server Name is used for the USB network storage,FTP and media server.
FTP Server
Select Enable to
set this Router as an FTP Server. Otherwise, select Disable to
turn the service off. An external USB hard drive or USB disk
must be connected to the USB Port to use this service.
Internet Access
Select Enable to allow access of the FTP
Server from the Internet. Otherwise, select Disable to only
allow local network access.
FTP Port
Enter the FTP Port number to use. The default port is 21. |
|
Access |
This
section lets you add FTP folders that can be accessed through
the FTP client. Click Specify Folder to
Access to add a FTP folder to the Access table.
If you
click Specify Folder to Access, the
FTP Folder screen appears.
To
add an FTP folder on FTP Folder screen:
-
Enter a display name that will appear in the Access table of
the FTP Server screen.
-
If you want to share the entire partition, click
the check box for Share entire
Partition. If you want to share the specific folder, select
a folder name to share. To see a sub-folder, click
Enter into Folder. To return to
the previous folder, click Return to
Upper Folder. To create a new folder, enter a name in
the New Folder field, then click
Create.
-
Select the right Access arrows to allow access to a group or
the left arrows to remove access to a group. You can allow
Read and Write or Read Only access. To add more groups, go
to Storage > Administration.
-
Click Save Settings to apply your
changes, or click Cancel Changes
to cancel your changes. Click Close
to close the screen.
Each
Display Name you created on the FTP Folder
screen will be listed with its partition and folder, which you
can edit or delete. Select Edit to
edit an item or Delete to delete the
item.
If you
click Edit, the
FTP Folder screen appears. Refer to
FTP Folder Screen section. |